This also applies to cable, chain, and webbing.
Gear that is anchored includes anchors, rocks, trees, tripods, trucks, etc.
A "bight" is a simple loop in a rope that does not cross itself.
A "bend" is a knot that joins two ropes together. Bends can only be attached to the end of a rope.
A "hitch" is a type of knot that must be tied around another object.
"Descending devices" (e.g., ATCs, Brake Bar Racks, Figure 8s, Rescue 8s, etc) create friction as their primary purpose. The friction in descending devices is always considered when calculating forces.
The "Safety Factor" is the ratio between the gear's breaking strength and the maximum load applied to the gear (e.g., 5:1).
vRigger includes flaked (aka "stacked") ropes. As shown here, they look best when you use benders to curve the rope where it enters and exits the pile of rope.
If the rope comes out of the bottom of the flaked rope, you can use the reverse rope routing property to swap the rope's entry and exit points. You might also add a stopper knot as shown above.